Teamac Marine High Performance 2 Pack Zinc Phosphate Primer
£139.14 (inc. VAT)
£115.95 (ex. VAT)
- UK manufactured, trusted brands
Teamac High Performance Marine Primer is a premium two-pack epoxy primer with zinc phosphate, delivering exceptional corrosion resistance above and below the waterline. Formulated to perform in harsh maritime environments, this coating is designed to extend the life of marine vessels, infrastructure and structural steelwork.
Ideal for use on blast-cleaned or properly prepared steel, aluminium, GRP and timber surfaces, it forms an outstanding bond with the substrate and acts as a long-term protective foundation for a wide range of topcoats including Teamac High Performance Gloss and Antifoulings.
✅ Ultimate marine-grade anticorrosive protection
✅ Suitable for yachts, dinghies, cruisers and commercial vessels
✅ Bonds excellently to steel, GRP, wood and aluminium
✅ High-build coating for demanding environments
✅ Supplied as a complete base and hardener system
✅ Compatible with most 1-pack and 2-pack topcoats
Surface Preparation
-
Surfaces must be clean, dry and contaminant-free
-
Blast cleaning to SA 2½ is recommended
-
Where blasting is impractical, perform mechanical abrasion
-
Degrease thoroughly before preparation
-
Ensure welds, edges and bolt heads are fully cleaned
-
Not suitable as a weld-through primer
Tech Data
| Property | Detail |
|---|---|
| Type | Two-pack epoxy zinc phosphate primer |
| Finish | Eggshell |
| Colours | Grey, Red |
| Pack Sizes | 1L and 5L (supplied as full units) |
| Coverage | 12 m² per litre @ 44μm DFT |
| Volume Solids | 52.5% |
| WFT / DFT | 85–190μm / 44–100μm |
| Touch Dry | 1.5–2 hours @ 20°C |
| Hard Dry | 16 hours @ 20°C |
| Recoat Time | 2–4 hours |
| Full Cure | 3–5 days @ 20°C |
| Pot Life | 4 hours @ 20°C |
| Application Temp | Above 5°C; avoid >90% humidity |
| VOC Content | <500 g/L |
| Flash Point | 25°C (closed cup) |
| Application Methods | Airless spray or brush |
| Spray Setup | Tip: 0.021"–0.027", Pressure: 1800–2300 psi |
| Thinner / Cleaner | Do not thin. Clean with Epoxy Cleaner 39 |
Directions for Use
-
Mix 3 parts base to 1 part activator by volume
-
Mix thoroughly with a slow-speed electric mixer for at least 2 minutes
-
Apply using brush or airless spray
-
Do not apply below 5°C or in high humidity (>90%)
-
Recoat between 2–4 hours depending on conditions
-
Clean tools immediately after use to prevent curing in lines
Data Sheets
Teamac Marine High Performance 2 Pack Zinc Phosphate Primer - TDS
Teamac Marine High Performance 2 Pack Zinc Phosphate Base - MSDS
Teamac Marine High Performance 2 Pack Zinc Phosphate Activator - MSDS
Use collapsible tabs for more detailed information that will help customers make a purchasing decision.
Ex: Shipping and return policies, size guides, and other common questions.
